Hi All,

We started the project this summer at Paul Neese’s Street Rod Welding and Fabrication in Hurst, TX.  A set of American Stamping rails were used with an 8″ Ford rear-end. It will run a 283 cu.in. Chevy V-8 with a powerglide or possibly a ’48 Merc flat motor if I’m able to acquire it.  An old dropped axle which will be drilled with split wishbones front and rear.  We have a floor in it now and readt to whack the top.  We have to brace the “B” pillars first and install bear claw door latches.  The car will get a ’35 Chevy Std. Dash (with instrument cluster in the center) really looks good, like it was made for it; after a little “tweakin” of course.  I’m very excited about the project, since with will be my first real early Hot Rod.  So here’s a few before and after shots. Dean.